This project is read-only.

Truxtor Quickstart guide

pre alpha release, the code works also on ST STM32F4discovery board

step by step:
1) update STM32discovery firmware using TRUX.DFU
2) install the .NETMF drivers from
3) start discovery in normal (non DFU boot) mode, use BOTH USB Cables!
4) start visual studio
5) open "Trux test.sln"
6) press F5 in VS
7) White LED on truxtor-stm32f4 board should blink

for discovery board you need to edit the GPIO pin number to use the led on disco board

this WORKS on unmodified discovery board, no need to change the crystal!!

Last edited Mar 19, 2012 at 3:11 PM by trioflex, version 10


No comments yet.